In order to prevent an electrical
shock, be sure to turn power off before performing work by touching the
interior parts of the product.
[Previous page][Next page][Table of Contents]
15. GAME BOARD
In order to prevent an electrical
shock, be sure to turn power off before performing work by touching the
interior parts of the product.
Be careful so as not to damage wirings. Damaged wiring can cause an electric shock or short circuit accident.
Do not expose the Game BD, etc. without a good reason. In this product, setting changes are made during the test mode. The Game BD need not be operated. Use the Game BD, etc. as is with the same setting made at the time of shipment.
16 - 1 REMOVING THE IC BOARD
To replace the IC BD (such as Game Board, Drive BD, etc.), or to change DIP SW settings, take out the IC BD by using the following procedure:
(1) Turn the MAIN SW off.
(2) Unlock and take off the 2 truss screws from the inside of the base as shown.
(3) Turn the knob to unlock. The seat can be inclined in the direction shown. When inclining the seat, be careful so as not to damage the seat parts. Carefully cause the backrest portion of the seat to come into contact with the floor. If the floor has hard surfaces, protect the seat from damage by using a cloth, etc. on the floor
(4) Take off the 3 screws to remove the case lid. The Game BD is contained in the Shield Case.
(5) Take off a total of 4 screws from both sides with the seat being in an inclined state and remove BASE LID F. Removing Base Lid F allows ELEC BASE to be viewed.
16 - 2 COMPOSITION OF GAME BOARD
(1) GAME BD SRT TWIN
(833-13374)
